Bradford White EFR160T120 Series Installation & Operating Manual page 60

To Display and Change Temperature Setpoint:
Step 1: In "Service Mode" press the "Select" button until "Setpoint" is shown in the water heater display.
Step 2: Press the "Set" button to enter the setting mode. "Setpoint" will flash in the water heater display.
Note: The maximum temperature that can be set in the Water Heater Display is limited to the "Max
Setpoint" described previously. To change the "Max Setpoint", refer to the procedure "To Change the
Maximum Setpoint Limit..." described previously under "Accessing the Service Mode on the Water Heater
Display".
Step 3: To raise the temperature setpoint, press the "Temperature Up" button until the desired temperature is
shown on the water heater display.
idle
Status Operational

SELECT
idle
Status
SELECT
NOTICE
idle
Status
SELECT
setpoint
°F
SET
"Setpoint" Flashes
setpoint
°F
Operational

SET
"Setpoint" Flashes

setpoint
°F
Operational
SET
60