AMX NXA-WAPZD1000 Operation/Reference Manual page 49

Configure Tab - System (Cont.)
IP Address:
Netmask:
Gateway:
Primary DNS Server:
Secondary DNS Server:
VLAN:
Management Interface
Enable Management Interface:
IP Address:
Netmask:
VLAN:
Smart Redundancy:
Enable Smart Redundancy:
Local Device IP Address:
Peer Device IP Address:
Shared Secret:
Management IP Address:
Management Access Control:
Name:
Restriction:
IP Address:
System Time:
NTP Server:
Country Code:
Channel Optimization:
Log Settings:
Event Log Level:
Remote Syslog:
NXA-WAPZD1000 ZoneDirector Smart WLAN Controller
The current IP address being used.
The current netmask being used.
The current gateway being used.
The current primary DNS server being used.
The secondary DNS server being used.
The VLAN setting being used.
Click the "Enable Management Interface" link to open the Management
Interface.
Check this box to allow information to be entered in the Management
Interface fields.
The IP address for the server used for management.
The netmask for the server used for management.
The VLAN for the server used for management.
Smart Redundancy allows continued operation of your network in the
event of an NXA-WAPZD1000 failure or power loss by allowing a
connection to a second NXA-WAPZD1000. If the active NXA-
WAPZD1000 loses connection, the standby device automatically takes
over.
Click this box to enable the Smart Redundancy fields.
The current IP address for the active NXA-WAPZD1000 in the network
The IP address for the standby NXA-WAPZD1000.
A shared password to be used between the active and standby NXA-
WAPZD1000 devices.
The IP address for the server used to manage the network. (If the
Management Interface has not been enabled, this field will be disabled.)
This section lists the specific IP addresses which are allowed access to
the NXA-WAPZD1000.
The name of the device or network accessing the NXA-WAPZD1000.
Select between "Single," "Range," and "Subnet".
• Single: allows only one specific IP address.
• Range: allows all IP addresses within a predetermined range.
• Subnet: allows all IP addresses within a predetermined subnet range.
The IP address or address range, depending upon the chosen Restriction.
Click the Refresh button to update the displayed time and date, Click the
Sync Time With Your PC button to synchronize the NXA-WAPZD1000's
time with your PC. After choosing to synchronize the time with your PC,
click the Apply button to update the time.
Check the Use NTP to synchronize the NXA-WAPZD1000 clock automati-
cally box to access a particular NTP server for the current time. Enter the
URL of the NTP server to be accessed in the NTP Server field.
Select the country in which the NXA-WAPZD1000 is being used.
Select between the three options to optimize for compatibility,
interoperability, or performance.
Select the level by which network events will be logged.
Click the Enable Syslog box to allow logging to be conducted by a remote
server. Enter the server IP address to allow remote logging.
Configure Tab
45