Monitoring and Controlling
ESC/VP21 Commands (EB-W16 only)
You can control the projector from an external device using ESC/VP21.
Before getting started
Connect the computer's serial port (D-Sub 9 pin) and the projector's
RS-232C port with a PC serial cable.
• Connector shape: D-Sub 9-pin (male)
• Projector input port name: RS-232C
<At the projector>
<At the projector>
Signal Name
Function
GND
Signal wire ground
TD
Transmit data
RD
Receive data
<At the computer>
(PC serial cable)
<At the computer>
Command list
When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error message is
output and a ":" is returned.
The main contents are listed below.
Add a Carriage Return (CR) code (0Dh) to the end of each command and
transmit.
Item
Power ON/OFF
On
Off
Signal selection
Computer1 or Com-
puter
Computer2 (EB-
W16 only)
HDMI
Video
S-Video
USB Display
USB
A/V Mute On/Off
On
Off
69
Command
PWR ON
PWR OFF
Auto
SOURCE 1F
RGB
SOURCE 11
Component
SOURCE 14
Auto
SOURCE 2F
RGB
SOURCE 21
Component
SOURCE 24
SOURCE 30
SOURCE 41
SOURCE 42
SOURCE 51
SOURCE 52
MUTE ON
MUTE OFF