FJ1 jumper (beside the AGP slot)
This jumper sets the default boot-up CPU frequency and the group of FSB frequencies that can be
selected in the BIOS.
CPU FSB
FJ1 Jumper
Configure Memory
Step 2.
This motherboard support PC2100 and PC2700, non-ECC and non-registered module.
The largest memory capacity possible is 2GB. On this motherboard, DRAM speed can
be set independent from the CPU front side bus speed. A maximum of 2 pcs.
Double-sided module can be used at the same time.
Memory Configuration Table
DDR1
Double sided
Double sided
Double sided
Single sided
Note: System must have 533MHz FSB CPU to have PC2700 memory support.
Memory Settings
FJ1 jumper allows you to change the DRAM Frequency (DRAM multiplier) for this motherboard. This
setting will have a corresponding DRAM multiplier table which can be modified by using the "DRAM:
CPU multiplier " option in the BIOS.
SY-P4I845PE Lite Quick Start Guide
Auto Detect FSB
100MHz FSB
3 2 1
DDR2
Double sided
Single sided
Single sided
Single sided
9
133MHz FSB
(Default)
3 2 1
3 2 1
DDR3
None
None
Single sided
none