Table of Contents
Advertisement
R
7.3
HYDRAULIC SYSTEM
A. CHECKING HYDRAULIC OIL LEvEL
The hydraulic oil level should be checked after the first 10
hours of operation. Thereafter, check the oil after every
200 hours of machine operation or monthly, whichever
occurs first.
- IMPoRtANt -
If the oil level is consistently low, check for leaks
and correct immediately.
1.
Wipe dirt and contaminants from around the
reservoir cap. Remove the cap from the hydraulic oil
reservoir.
2.
Visually check the level of hydraulic oil. Hydraulic
oil must be at least 3" inches from top of the filler
neck. If the level cannot be determined visually,
use a clean tape measure to check the level. If the
fluid is low, add 20W50 motor oil. DO NOT overfill;
(overfilling the oil reservoir may cause oil seepage
around the cap area).
3.
Clean the fill cap and install it onto the reservoir.
Figure 7-2.
Hydraulic oil Reservoir
B. CHANGING HYDRAULIC OIL
The hydraulic oil should be changed after every 500 hours
or annually, whichever occurs first. The oil should also be
changed if the color of the fluid has become black or milky.
A black color and/or a rancid odor usually indicates possible
overheating of the oil, and a milky color usually indicates
water in the hydraulic oil.
1.
2.
3.
4.
5.
Hydraulic Oil
Reservoir
HYDRAULIC
OIL FILTER
2007 STT HOR
C. CHANGING HYDRAULIC OIL FILTER
ELEMENT
The hydraulic oil filter should be changed after every 500
hours of operation or annually, whichever occurs first.
1.
34
- IMPoRtANt -
The hydraulic oil should be changed if you notice
the presence of water or a rancid odor to the
hydraulic oil.
Park the mower on a level surface and stop the
engine.
Place a suitable container under the hydraulic oil
filter. Remove the fill cap from the reservoir. Remove
the hydraulic oil filter. (See Figure 7-3). Allow the
fluid to drain into the container and properly discard
it.
Install a new filter element. See Procedure C.
- Note -
Before refilling the hydraulic oil reservoir the
hydraulic oil filter should be changed as outlined
in Procedure C "Changing Hydraulic Oil Filter
Element" on the next page.
Fill the reservoir to 3" inches from the top of the filler
neck with 20W50 motor oil.
Replace the reservoir fill cap. Start the engine and
drive forward and backward for two minutes. Check
the oil level in the reservoir. If necessary, add oil to
the reservoir.
Figure 7-3.
Hydraulic oil Filter
Remove the oil filter element (Figure 7-3) and
properly discard it. Fill the new filter with clean oil
and install the filter. Hand tighten only.
Section 7
390S0155-1
Hide quick links:
Advertisement
Table of Contents
