Table of Contents
Advertisement
R
Figure 2-4.
Slope Angle Graph
WARNING
Reduce speed when turning, operating on slopes,
slick or wet surfaces. Allow extra distance to
stop.
Stay off of slopes too steep for safe operation.
To check a slope, attempt to back up it (with the
cutter deck down). If the machine can not back
up the slope without the wheels slipping, do not
operate the machine on this slope. Under no
circumstances should the machine be operated
on slopes greater than 15 degrees. See Figure 2-4
to determine approximate slope.
DO NOT mow near drop-offs, ditches or
embankments. The machine could suddenly roll
over if a wheel goes over the edge or if the edge
caves in.
Operate the machine smoothly, no sudden turns,
starts or stops on a slope.
NEvER tow on slopes. The weight of the towed
equipment may cause loss of traction and loss
of control.
DO NOT permit untrained personnel to operate
the machine.
Be cautious when loading and unloading onto
trailers or trucks.
Use only a full width ramp.
Ramp angle should be no more than 15 Degrees.
See Figure 2-4 to help determine approximate
slope.
Back up the ramp and drive down forward.
2.6
MAINTENANCE CONSIDERATIONS &
STORAGE
o
20
1.
Never make adjustments to the machine with the
o
15
engine running unless specifically instructed to do
o
10
so. If the engine is running, keep hands, feet, and
clothing away from moving parts.
5
o
2.
Disengage drives, lower implement, set parking
brake, stop engine and remove key or disconnect
spark plug wire to prevent accidental starting of the
engine when servicing or adjusting the machine.
Wait for all movement to stop before adjusting,
cleaning or repairing.
3.
Disconnect battery or remove spark plug wire before
making any repairs. Disconnect the negative terminal
first and the positive last. Reconnect the positive first
and the negative last.
4.
Keep all nuts, bolts and screws tight, to ensure the
machine is in safe working condition. Check blade
mounting bolts frequently to be sure they are tight.
5.
Do not change the engine governor settings or
overspeed the engine. See the engine operator's
manual for information on engine settings.
6.
To reduce fire hazard, keep the cutting units, drives,
muffler and engine free of grass, leaves, excessive
grease, oil and dirt.
7.
Park the machine on level ground and engage the
parking brake.
8.
NEVER allow untrained personnel to service the
machine.
9.
Use care when checking blades. Use a Blade Buddy,
wrap the blade(s) or wear gloves and USE CAUTION
when servicing blades. Only replace blades. NEVER
straighten or weld blades.
10.
Keep all parts in good working condition. Replace all
worn or damaged decals.
11.
Use jack stands to support components when
required.
12.
Carefully release pressure from components with
stored energy.
8
Section 2
Hide quick links:
Advertisement
Table of Contents
