Traditional Whirlpool (With Jets) - Operating Instructions - European Touch FORTE’ Owner's Manual

Traditional Whirlpool
After the pedicure spa is installed and the plumbing and electrical connections are made, clean and
disinfect the basin before initial use. Rinse the basin by using the attached w ater sprayer. Wipe the
basin dry w ith a clean tow el.
To Operate the Pedicure Spa, Follow These Easy Steps:
Adding Water to the Pedicure Spa Basin:
1. Close the drain by turning the chrome drain handle counter-clockw ise until it stops.
2. Add water to the basin by lifting upw ard on the w ater faucet fill handle. Turn the handle in a
counter-clockw i s e direction for cold water or clockwise for warm w ater as indicated by the red
(hot) and blue (cold) markings around the handle ( CAUTION: hot w ater can burn skin). Continue
to add w ater until the fill line is reached. The fill line is indicated by the w avy (~~~~) line in the
basin.
3. Turn the off water by pushing the handle dow nward and center.
Operating the Water Jets:
Each pedicure spa is equipped w ith two fully adjustable jets that create a soothing foot massage. To
operate, turn the w hirlpool jets on by turning the On/Off Sw itch in a clockw ise direction. To increase jet
strength, open each jet by simply rotating the adjustment cover in a counter-clockw ise direction. To
decrease water pressure, close each jet by rotating the adjustment cover in a clockw ise direction
(NOTE: The Jet heads should not be positioned directly at the suction cover. Doing so will
create a noisy "gurgling" sound as air is being forced directly into water pipes). Turn off the
whirlpool jets by turning the On/Off sw itch counter-clockw ise to its original starting position.
Rem oving Water from the Pedicure Spa Basin:
First, make certain the w hirlpool jets are off by turning the On/Off Switch counter-clockw ise to the "Off"
position.
If the pedicure spa is hooked up directly to a floor drain, simply open the drain by turning the drain
handle in a clockw ise direction until it stops. You should see the w ater level low ering as w ater exits the
basin.
If the pedicure spa is equipped w ith the optional Pow er Drain Pump ( PDP) feature, open the drain by
turning the drain handle in a clockw ise direction until it stops, and then press the button marked " Drain"
on the front panel. The w ater level w ill low er as water i s pumped out of the basin. Turn the pump off
by pressing the "Drain" button on the front panel once the basin is fully drained. (NOTE: The Power
Drain Pump will automatically shut off after 2-1/2 minutes. We recommend turning off the pump
manually if all water has drained before automatic shut-off.)
Warning:
It is extremely important to follow the cleaning instructions located on the following page.
Failure to clean the pedicure spa adequately can result in serious health issues for your clients
as well as the nail technician. Failing to clean your pedicure spa may also cause the pedicure
spa to not work properly. Please consult your local and state codes concerning pedicure chair
cleaning for further requirements.
Document ID:06080001
- Operating Instructions
(With Jets)
Rev: E Technical Support: 800-626-6912 Page 19 of 24