Attaching The Cushions - European Touch FORTE’ Owner's Manual

All pedicure spa cushions attach to the pedicure spa with Velcro. The Forte' and Altera Pedicure spas
have cables for the cushions that need to be routed proper ly. Follow these instructions for attaching
the cushions properly to your pedicure spa:
Step 1: Your pedicure spa will
come with the Velcro already in
place for the seat bottom and the
seat back.
Step 2: Attach the seat bottom to
the chair bottom. Make sure that
the cushion is centered on the
chair bottom. The arms should be
able to close without cushion
interference.
Step 3: Route the seat back
cushion cables underneath the
chair back and out the back.
Center the seatback cushion on
the chair back.
Document ID:06080001

Attaching the Cushions

Step 4: Remove the protective film
from the Velcro on the bottom of
the arm pads. Carefully place the
arm pads on the chair arms and
slide the remotes under the remote
holders on the arm pads.
Step 5: FORTE' ONLY – The
remote control and power supply
cord are taped together behind the
chair. Remove the tape and
connect the cords from the cushion
to these connectors.
Step 6: FORTE' ONLY – Route
the seat back cables through the
hole in the pedicure spa base.
Rev: E Technical Support: 800-626-6912
Step 7: ALTERA VIBRATION
ONLY – The Altera cushion remote
control comes attached to the
junction box.
Step 8:
ALTERA VIBRATION
ONLY – The Altera junction box
should be mounted on the back of
the seat back. Plug the 2 cushion
cords into the red and white
receptacles (they can go into either
receptacle). The power supply
cord plugs into the receptacle next
to the remote cord. Plug the power
supply into the power strip.
Step 9: The remotes can be
slipped into the ar mrests as
show n.
Note: Close side arms rests before
operating the chair seat movement.
Page 15 of 24