Specifications - European Touch FORTE’ Owner's Manual

Hot and cold w ater supply lines required (hot and cold shut offs may be installed under pedicure spa
Drain installation:
Overall dimensions without accessories, seat upright: 54" (138cm) L x 31" (79cm) W x 56" (143cm) H*
Without accessories, seat collapsed: (shipping position): 54" (138cm) L x 32" (82cm) W x 36" (92cm) H*
Shipping dimensions:
Em pty weight:
Shipping weight:
Capacity of basin:
Whirlpool pump motor: 110V: 1/6 HP, 110V, 60HZ (alternate voltages available) (3/4 HP for Traditional
Forte' seat and back motors: 30V DC Linear Actuators. Forte' requi r es 18" (46 cm) of space bet w een
Altera seat and back movement: 2 infinitely adjustable lockable gas cylinders for reclining/sliding. The
Massage motor:
Power source:
Caution: Pedicure spa must be installed by a licensed electrician and a licensed plumber,
Construction:
™
Crystal Clean Pipe-Free
Hydro-Therapeutic (Jet System : Traditional Whirlpool pedicure spas): PVC, two (2) fully-directional
Electrical switches:
UL listed/CE certified:
Performance Lim its:
Lim ited warranty:
Due to our policy of continuous improvements, all specifications are subject to change without notice.
Document ID:06080001

Specifications

base) See pages seven through ten.
references noted on pages seven through ten, can be installed with optional
power drain pump or as gravity drain.
55" (140cm) L x 33" (84cm) W x 41" (105cm) H*
150 Ibs (68kg)*
205 lbs (93kg)*
5 U.S. Gallons (18.9L) = Traditional Whirlpool (with Jets)*
6.5 U.S. Gallons (25.6L) = Crystal Clean
Whirlpool - with Jets)
220V: 1/6 HP, 110V, 50Hz (alternate voltages available) (3/4 HP for Traditional
Whirlpool - with Jets)
pedicure spa and wall w ith standard actuator, and 25" (64 cm) w ith fully-reclining
actuator.*
Altera requires 12" (31cm) of space between pedi c ure spa and wall in order for
seat to recline to its fullest extent.*
12V AC, Adapter included (alternate voltages available)
110V: 110V AC / 15 Amp, 60 Hz (GFCI Protected)
220V: 220-240VAC, 50Hz, 7.5 Amp (GFCI Protected)
conforming to all local and national electrical codes.
Linear Low Density Polyethylene (LLDPE), self-contained, pre-plumbed
®
w ater m assage system (pipe-free pedicure spas): 'underfoot' footplate
water massage grooves, no closed loop circulating pipes, 100% fully drained,
and cleanable
jets, built-in air control
On/Off switch for whirlpool pump. Hand-held low voltage remote controls for
massage motors, heat, and seat/back position hot and cold water supply lines
required
Complies w ith ASME/ANSI Whirlpool Bathtub Specs ASME/ANSI A112.19 7M-
1995 and A112.19.8M-1995. Backflow Protection Devices for Faucets w ith Side
Spray: Check val v es comply with ANSI/ASME A112.18.3M, A112.18.1M, and
CSA B125.
1. This unit may loose one ore more functions when electrostatic contact
discharge in excess of 4KV gets into accessible conductive part of the unit and
can be restored by resetting the unit.
2. This unit may loose one ore more functions when power surge in excess of
2KV is applied to the AC input power port and can be restored by resetting the
unit.
3. This unit may loose one ore more functions when subjected to fast transient
voltages in excess of 0.5KV at 5 KHz repetition frequency and can not be
restored.
One (1) year from date of purchase.
Rev: E
™
Pipe-Free
*Note: All dimensions and weights are approximate
Technical Support: 800-626-6912
®
*
Page 12 of 24