Connecting A Stereo Signal Source - Samson Expedition XP112a Owner's Manual

Connecting a Stereo Signal Source

The following steps describes connecting Stereo Line Level Signal to two Expedition
loudspeakers:
•
Set the Expedition XP112a/XP115a Power switch to the off position.
•
Turn the LEVEL control fully counterclockwise to the off position.
•
Connect the power cable to an AC socket.
•
Using standard XLR or 1/4" cables, connect the line level signals from a mixer or key-
board into the Expedition Inputs.
•
Set the SENSITIVITY switch to the LINE position.
•
Switch the Power switch to the ON position.
•
Now, run an audio signal from your mixer (like music from a CD) while slowly raising
the Expedition's Level control until you have reached the desired level.
Expedition XP112/XP115
9