Connecting The Resolv Rxa Monitors - Samson Resolv RXA5 Owner's Manual

Connecting the Resolv RXA Monitors

The Resolv RXA series monitors are the perfect addition to any studio. When con-
necting your monitors, you should utilize the control room outputs of your mixer so
that you can independently control the level to the speakers without affecting the
main mix output. Follow the simple steps and diagram in this section to quickly con-
nect your monitors using a standard recording console's control room outputs.
1. Lower your mixer's master outputs until they are completely off.
2. Connect the mixer's Left Control Room output to the left-side Resolv RXA
Series LINE INPUT and the mixer's Right Control Room output to the right-side
Resolv RXA Series LINE INPUT. The Resolv RXA series connections can be
made via one of the three rear panel Audio Inputs. You can use RCA inputs for
unbalanced, -10dBV level signals, or either the ¼" or XLR inputs for balanced,
+4dBu level signals.
Note: Before plugging in and powering on the speakers, remember the "last on, first off" rule of
power amplifiers (and powered monitors). When powering up your system, be sure that all the
wires are connected, turn your mixer and any other outboard gear on, and then finally turn your
Resolv RXA Series on.
3. Set the Resolv RXA Series input Volume control to the 12-o'clock (center detent)
position.
4. Run an audio signal (such as music from an MP3 player) through your mixer and
raise the Control Room level to a comfortable listening volume.
Resolv RXA Studio Monitors
Control Room Outputs
5