Ducati SuperBike 1098S Use And Maintenance Manual page 48

To adjust the position of the rear brake lever, proceed as
6 7
follows:
Loosen the locknut (4).
Turn the pedal travel adjustment bolt (5) until the pedal is in
the desired position.
When finished, torque locknut (4) to 2.3 Nm.
Operate the pedal by hand to check that there is 1.5 – 2 mm
of freeplay before the brake bites
E
If not, adjust the length of the master cylinder pushrod as
follows.
Slacken off the locknut (6) on the pushrod.
Tighten the link on the fork (7) to increase play, or unscrew it
to reduce.
4
Tighten counter nut (6) to 7.5 Nm and check the play again.
5
fig. 36
48