Ducati SuperBike 1098S Use And Maintenance Manual page 35

Brightness of warning lights
The brightness of warning lights is adjusted automatically by
the instrument panel according to the level of external light
detected.
Display backlight
The instrument panel backlight is switched on only if the
parking lights or low/high beam is on.
In this case the instrument panel, using sensors that
measure ambient temperature and light intensity,
automatically turn the backlight on or off.
Intelligent headlamp switch-off
This function is used to reduce the consumption of battery
power, by automatically switching off the front headlamp.
The device is triggered in 2 cases:
- in the first case, if you turn the key from OFF to ON and
do not start the engine within 60 seconds, the headlight
is turned off and will be turned on again only when the
engine is next switched on.
- in the second case, after normal use of the vehicle with
the lights on, if the engine is killed via the RUN-STOP
button on the RH switch.
In this case, the headlamp is switched off 60 seconds
after the engine is switched off, and only switched on
again the next time the engine is started.
Intelligent headlamp switch-on
This function allows programmed activation of the headlamp
even with the motorcycle off (Key-Off).
Immediately after key-off, the instrument panel remains active
for 60 seconds, thus allowing the headlamp to be switched
on if the button (1, fig. 8) is switched to position B "▼".
During these 60 seconds, each time the button (1, fig. 8) is
switched to position B "▼", the instrument enables you
switch on the headlamp for 30 seconds. Each time you
switch the button (1, fig. 8) to position B "▼", a further
30 seconds will be added to the switch-on time, up to a
maximum of 6 presses (the maximum time is 180 seconds).
After the first time you switch the button (1, fig. 8) to position
B "▼", the period of 30 seconds starts, thus switching on
the headlamp. Further switch-on time can be added only
if you press the button again within these 30 seconds.
If the 30 seconds have elapsed, no further multiples of
30 seconds can be added, and the instrument panel will
switch off the headlamp.
To return to this function, you must do at least one Key-On/
Key-Off.
If the battery power is interrupted at any time while this
function is active, when power is restored the instrument
panel will de-activate the function (the instrument panel
does not remain active for 60 seconds).
E
35