Ducati SuperBike 1098S Use And Maintenance Manual page 27

USB DAQ
This function activates the USB DAQ (see page 66): the DAQ
must be connected to the motorcycle wiring.
To activate the DAQ, go into the menu and set the USB DAQ
to "On" by holding the button (1, fig. 8) in position B "▼"
for 3 seconds.
START and STOP the lap separator by pressing the high
beam FLASH button (12, fig.5) on the left-hand switch.
E
If the USB function is active and the display is suddenly
switched off (Key-Off), the function is switched off
automatically.
fig. 21
27