Table of Contents
Advertisement
Insignia 32" LED TV
Problem
Solution
Good picture, but
• Increase the volume.
no sound.
• Make sure that the sound is not
• Make sure that you do not have
• Change to a different audio
• If you are using a home theater
• If you are using a home theater
• Make sure that the audio cables
• Make sure that the antenna or
• If you are using an antenna, the
• The audio cables you are using
Poor picture.
• Make sure that the room is not
• If an S-VHS camera or a
Good sound, but
• Adjust the contrast, color, and
poor color.
Audio noise.
• Other devices (for example, a
muted.
headphones connected. When
headphones are connected, no
sound comes from the TV
speakers.
mode.
system, sound bar, or external
speaker system, make sure it is
turned on and is not muted.
system, sound bar, or external
speaker system and have
connected it with a digital
optical cable, set the Digital
Audio/SPDIF option on the
AUDIO menu to PCM. See the
Digital Audio/SPDIF option in
"Adjust sound settings" on
page 50.
are connected correctly and
securely to your TV.
cable TV is connected correctly
and securely. See "Connect a
cable or satellite box" on
page 13 or "Connect an
antenna or cable TV (no box)"
on page 18.
digital channel signal may be
low. To check the digital
channel signal strength, see
"Check the digital signal
strength" on page 54.
may be bad. Try a new set.
too bright. Light reflecting off
the screen can make the picture
difficult to see.
camcorder is connected while
another connected device is
turned on, the picture may be
poor. Turn off one or more
devices.
brightness settings. See "Adjust
the TV picture" on page 47.
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device at a time to determine
which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
www.insigniaproducts.com
Problem
Solution
No output from
• Adjust the audio balance. See
one of the
speakers.
• Make sure that the audio cables
After images
• Do not display a still image,
appear.
Remote control
Problem
Solution
Remote
• Make sure that the AC power
control does
adapter is correctly connected to
not work.
your TV and a power outlet.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly
at the remote control sensor on
your TV. For the location of the
remote control sensor, see "Front"
on page 8.
• The supplied batteries are
wrapped tightly in clear plastic.
Make sure that you have removed
this plastic from the batteries.
• Make sure that the batteries are
installed correctly. See "Install
remote control batteries" on
page 35.
• Replace dead batteries with new
batteries. See "Install remote
control batteries" on page 35.
Trouble
• See instructions and a table of
programming
common codes in "Program
your existing
universal remote controls" on
universal
page 72.
remote
• Codes are subject to change. For
control.
up-to-date codes, go to
www.insigniaproducts.com/remotecodes
• Replace dead batteries with new
batteries. Refer to the User Guide
that accompanied your universal
remote control.
• Refer to the User Guide that
accompanied your universal
remote control and contact the
manufacturer if problems persist.
"Adjust sound settings" on
page 50.
are connected correctly and
securely to your TV.
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent
after-image to be burned into
the screen. This type of damage
is not covered by your warranty.
67
Advertisement
Table of Contents
