General Database Information; Database Versions; Database Updates - Garmin 400 Series Pilot's Manual Addendum

General Database Information

Garmin TAWS uses terrain and obstacle information supplied by government sources. The data under-
goes verification by Garmin to confirm accuracy of the content, per TSO-C151b. However, the displayed
information should never be understood as being all-inclusive. Pilots must familiarize themselves
with the appropriate sectional charts for safe flight.
NOTE: The data contained in the terrain and obstacle databases comes from government

agencies. Garmin accurately processes and cross-validates the data, but cannot guarantee
the accuracy and completeness of the data.
The terrain/obstacle databases are contained on a datacard which is inserted in the right-most slot of
the 400/500 Series units.

Database Versions

The version and area of coverage of each terrain/obstacle database is shown on the Terrain Database
Versions Page, located in the AUX Page Group (Figure 2-8). Databases are checked for integrity at power-
up. If a database is found to be missing and/or deficient, the TAWS system fails the self-test and displays
the TAWS system failure message (see page 59).

Database Updates

Terrain/obstacle databases are updated periodically with the latest terrain and obstacle data. Visit the
Garmin website to check for newer versions of terrain/obstacle databases (compare database cycle num-
bers to determine if a newer version is available). Updated terrain data cards may be obtained by calling
Garmin at one of the numbers listed in the front of this document.
To update your terrain/obstacle databases:
1. Acquire a new terrain data card from Garmin.
2. Turn off the power to the 500 Series unit.
3. Remove the old terrain data card from and insert the new card into the right-most slot of the
500 Series unit.
4. Turn on the 500 Series unit and verify that the TAWS system passes self-test.
Section 2
TAWS Operation
Figure 2-8: Terrain Database Information
51