Table of Contents
Advertisement
Start/Pause
9
Door light
10
At the end of the programme
The appliance stops automatically. The pilot
light of the button 8 and the pilot light 7.1 go
off. The display shows
If a programme or an option that ends with wa-
ter left in the tub has been selected, the pilot
light 7.1 remains on and the door is locked to
indicate that the water must be emptied out be-
fore opening the door.
Follow the below instructions to empty out the
water:
www.zanussi.com
Start the programme by pressing the button 8
• To start the selected programme, press the button 8, the
corresponding green pilot light stops flashing. The pilot light
7.1 illuminates to indicate that the appliance starts operat-
ing and the door is locked. If you have chosen a delayed
start, the appliance will begin the countdown.
• To interrupt a programme which is running, press the but-
ton 8: the corresponding green pilot light starts flashing. It
is possible to change some options of a running pro-
gramme before the programme carries them out.
• To restart the programme from the point at which it was in-
terrupted, press the button 8.
• After the programme has started the door is locked. If, for
any reason, you need to open the door, set firstly the ap-
pliance to PAUSE by pressing the button 8. After a few mi-
nutes it will be possible to open the door.
If the door remains locked, this means that the appliance is
already heating or that the water level is too high. In any
case, do not try to force the door!
If you cannot open the door but you need to open it you
have to switch the appliance off by turning the selector dial
to
. After a few minutes the door can be opened (pay
attention to the water level and temperature!). After
closing the door, it is necessary to select the programme
and options again and to press the button 8.
The pilot light 7.1 illuminates when the programme starts and
indicates if the door can be opened:
• light on: the door cannot be opened. The appliance is work-
ing or has stopped with water left in the tub.
• light off: the door can be opened. The programme is finish-
ed or the water has been emptied out.
• light blinking: the door is opening in a few minutes.
.
• Turn the programme selector dial to
• Select the draining or spinning programme.
• Reduce the spin speed if needed, by press-
ing the relevant button.
• Press the button 8.
At the end of the programme, the door can be
now opened. Turn the programme selector dial
to
to switch the appliance off. Remove the
laundry from the drum and carefully check that
the drum is empty. If you do not intend to carry
out another wash, close the water tap. Leave
.
19
Hide quick links:
Advertisement
Table of Contents
