Zanussi ZWH 7100 P User Manual page 10

Push the drain hose onto the spigot and se-
cure with a clip, ensure a loop is formed in
the drain hose to prevent waste from the sink
entering the appliance.
If the outlet spigot has not been used before,
remove any blanking plug that may be in
place.
• Directly into a drain pipe at a height of
not less than 60 cm and not more than
100 cm.
Connections overview
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
Electrical connection
• The appliance must be earthed.
• Make sure that the electrical information on
the rating plate agree with your domestic
power supply.
10
The end of the drain
hose must always be
ventilated, i.e. the
inside diameter of the
drain pipe must be
larger than the out-
side diameter of the
drain hose. The drain
hose must not be
kinked.
min. 60 cm
max. 100 cm
• Directly to a built-in drain pipe in the
room wall.
The drain hose may be extended to a maxi-
mum of 4 metres. An additional drain hose
and joining piece is available from your Local
Centre.
max.
100 cm
~max.400 cm
• Always use a correctly installed shockproof
socket.
• Do not use multi-way plugs, connectors and
extension cables. There is a risk of fire.
• Do not replace or modify the mains cable
yourself. Contact the After Sales Service.
min.
60 cm
www.zanussi.com