Sanyo SAP-K77RAX Technical & Service Manual page 59

ON/OFF operation button
This button is for turning the air conditioner on and off.
Temperature setting buttons (TEMP.)
Press the
Press the
The temperature setting changes by 1 °C each time one of the TEMP. buttons is pressed.
The set temperature appears in the display for only 3 seconds.
FLAP button
Press this button either to select the setting of the airflow direction to the
auto. flap in each mode or one of the six possible positions manually or to
select the sweep function which moves the flap up and down
automatically.
NOTE
When you press the FLAP button, the air flow direction will be changed
one by one as follows.
CANCEL button
After using the TIMER ON button or TIMER OFF button to set the timer,
press this button to cancel the setting.
Jumper wire for address switching
• The address switch changes to prevent mixing of
signals from remote control units when two air
conditioners are installed next to each other.
For more information, please contact the dealer where
you made the purchase.
OI-018-7-EG
button to increase the set temperature.
button to reduce the set temperature.
: Auto flap setting: If selected in a cooling or dry operation, the flap
is set at position (7) in the following chart.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
SWEEP
Back side of remote
control unit
(Cover removed)
7