Deleting Files; Disconnecting The Usb Cable; Attaching The Wrist Strap; Attaching The Carabiner Clip - Garmin GPSMAP 64 Owner's Manual

Deleting Files

If you do not know the purpose of a file, do not delete it. Your
device memory contains important system files that should not
be deleted.
1
Open the Garmin drive or volume.
2
If necessary, open a folder or volume.
3
Select a file.
4
Press the Delete key on your keyboard.

Disconnecting the USB Cable

If your device is connected to your computer as a removable
drive or volume, you must safely disconnect your device from
your computer to avoid data loss. If your device is connected to
your Windows computer as a portable device, it is not
necessary to safely disconnect.
1 Complete an action:
• For Windows computers, select the Safely Remove
Hardware icon in the system tray, and select your device.
• For Mac computers, drag the volume icon to the trash.
2
Disconnect the cable from your computer.

Attaching the Wrist Strap

1
Insert the loop of the wrist strap through the slot in the
device.
2
Thread the other end of the strap through the loop, and pull it
tight.

Attaching the Carabiner Clip

1 Position the carabiner clip
spine of the device.
2
Slide the carabiner clip up until it locks in place.

Removing the Carabiner Clip

Lift up on the bottom of the carabiner clip, and slide the
carabiner clip off the mounting spine.
12
NOTICE
in the slots on the mounting

Device Care

Avoid chemical cleaners, solvents, and insect repellents that
can damage plastic components and finishes.
Do not store the device where prolonged exposure to extreme
temperatures can occur, because it can cause permanent
damage.
The device is water resistant to IEC Standard 60529 IPX7. It
can withstand accidental immersion in 1 meter of water for 30
minutes. Prolonged submersion can cause damage to the
device. After submersion, be certain to wipe dry and air dry the
device before using or charging.

Cleaning the Device

1
Wipe the device using a cloth dampened with a mild
detergent solution.
2
Wipe it dry.

Troubleshooting

Resetting the Device

If the device stops responding, you may need to reset it. This
does not erase any of your data or settings.
1 Remove the batteries.
2
Reinstall the batteries.

Restoring All Default Settings

You can reset all settings back to the factory default settings.
Select Setup > Reset > Reset All Settings > Yes.
NOTICE
Appendix