Mitsubishi WD-52627 Training Manual page 37

V28 Mechanical Adjustments
In the V28 chassis, the Mechanical Adjuster is accessed
from the rear. Refer to the disassembly instructions and
remove the BACK-COVER.
Tools Required:
• 2mm L shaped Allen wrench
• 4mm L shaped Allen wrench
• Hex wrench
Preliminary
(Refer to Figure 3-3)
Figure 3-3: Locking Screws & Nuts
3-3
1) Loosen the Fixing Screw (1) and (2) in the
Slide -Lock-Mate.
2) Loosen Nuts (1) and (2) on the Adjuster
3) Loosen [A-1] and [A-2] on the Adjuster (4mm
Allen wrench)