Cisco Catalyst 2960 Hardware Installation Manual page 25

Hide thumbs Also See for Catalyst 2960:
Table of Contents

Advertisement

Chapter 1
Product Overview
Table 1-5
Port Mode
STAT
(port status)
DUPLX
(duplex)
SPEED
PoE
Even if PoE mode is not selected, the PoE LED still shows PoE problems when they are detected.
Table 1-6
switches that support PoE.
Table 1-6
PoE Mode LED
Color
PoE Status
Off
PoE mode is not selected. None of the 10/100 or 10/100/1000 PoE ports have been denied power or are
in a fault condition.
Green
PoE mode is selected, and the PoE status is shown on the port LEDs.
Blinking amber
PoE mode is not selected. At least one of the 10/100 PoE ports has been denied power, or at least one of
the ports has a PoE fault.
OL-7075-05
Meaning of LED Colors in Different Modes on the Switch
LED Color
Meaning
Off
No link, or port was administratively shut down.
Green
Link present.
Blinking green Activity. Port is sending or receiving data.
Alternating
Link fault. Error frames can affect connectivity, and errors such as
green-amber
excessive collisions, cyclic redundancy check (CRC) errors, and
alignment and jabber errors are monitored for a link-fault indication.
Amber
Port is blocked by Spanning Tree Protocol (STP) and is not forwarding
data. After a port is reconfigured, the port LED can remain amber for
up to 30 seconds as STP checks the switch for possible loops.
Blinking amber Port is blocked by STP and is sending or receiving packets.
Off
Port is operating in half duplex.
Green
Port is operating in full duplex.
10/100/1000 ports
Off
Port is operating at 10 Mb/s.
Green
Port is operating at 100 Mb/s.
Blinking green Port is operating at 1000 Mb/s.
SFP module ports
Off
Port is operating at 10 Mb/s.
Green
Port is operating at 100 Mb/s.
Blinking green Port is operating at 1000 Mb/s.
Note
PoE port power The PoE status.
lists the PoE mode LED colors and their meanings. The PoE LED applies only to Catalyst 2960
1000BASE-T SFP modules can operate at 10, 100, or 1000
Mb/s in full-duplex mode or at 10 or 100 Mb/s in half-duplex
mode in the Catalyst 2960 switches.
Catalyst 2960 Switch Hardware Installation Guide
Front Panel Description
1-15

Advertisement

Table of Contents
loading

Table of Contents