Cisco Catalyst 2960 Hardware Installation Manual page 101

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Appendix C

Configuring the Switch with the CLI-Based Setup Program

Entering the Initial Configuration Information

To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal

emulation program or through the network by using Telnet. For configuration information, see the switch

software configuration guide or the switch command reference.

To use the Network Assistant, see the Getting Started with Cisco Network Assistant guide on Cisco.com.

Catalyst 2960 Switch Hardware Installation Guide

C-7

OL-7075-05

Table of Contents