Catalyst 2960G-24Tc-L And Catalyst 2960G-48Tc-L Switches - Cisco Catalyst 2960 Hardware Installation Manual

Front Panel Description
The Catalyst 2960-24LT-L, Catalyst 2960-24TT-L, and Catalyst 2960-48TT-L switches have two
10/100/1000 uplink ports, numbered 1 and 2. Ports 1 to 8 on the Catalyst 2960-24LT-L switch are
PoE ports. See
Figure 1-7
SYST
RPS
STAT
DUPLX
SPEED
PoE
MODE
1
2
Figure 1-8
1
Figure 1-9
1

Catalyst 2960G-24TC-L and Catalyst 2960G-48TC-L Switches

The 10/100/1000 ports on the Catalyst 2960G-24TC-L and Catalyst 2960G-48TC-L switches are
grouped in pairs. The first member of the pair (port 1) is above the second member (port 2), port 3 is
above port 4, and so on. The SFP module slots are numbered 21 to 24 on the Catalyst 2960G-24TC-L
switch and 45 to 48 on the Catalyst 2960G-48TC-L switch. See
The Catalyst 2960G-24TC-L and Catalyst 2960G-48TC-L switches have dual-purpose ports, meaning
ports 21 to 24 or 45 to 48 can use either the SFP module or the RJ-45 connector for that port, but not
both. Use the software to set the connector type for these ports. For more information about the
dual-purpose port, see the
Catalyst 2960 Switch Hardware Installation Guide
1-6
Figure 1-7, Figure
Catalyst 2960-24LT-L Switch Front Panel
10/100 ports PoE ports
10/100 ports
Catalyst 2960-24TT-L Switch Front Panel
10/100 ports 2 10/100/1000 uplink ports
Catalyst 2960-48TT-L Switch Front Panel
10/100 ports 2 10/100/1000 uplink ports
"Dual-Purpose Port" section on page
1-8, and Figure 1-9.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
1X 1X 11X 13X
2X 2X 12X 14X
POWER ETHERNET
OVER
1
3
10/100/1000 uplink ports
1
1
Chapter 1
Catalyst 2960 Series PoE-8
16 17 18 19 20 21 22 23 24
23X
1 2
24X
2 3
2
2
Figure 1-10 and Figure
1-11.
Product Overview
1-11.
OL-7075-05