Setting Up Wpa-Psk Security - NETGEAR WG311T User Manual

Setting up WPA-PSK Security

Follow the steps below to configure WPA-PSK Security.
1. Run the WG311T Smart Wizard.
a. Make sure the WG311T software is installed and the WG311T is properly installed in a
PCI slot in your computer.
b. Use the icon to open the Smart Wizard. The Settings tab page opens.
Figure 4-9
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.
c. In the Security section, select WPA-PSK [TKIP] and enter the passphrase. The passphrase
can be a word or a group of printable characters.
For more information on WPA security, see the Web link to
in Appendix B.
User Manual for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
v4.0, February 2006
"Wireless Communications:"
4-13