Starting A Computer-To-Computer (Ad Hoc) Network Connection - NETGEAR WG311T User Manual

At this point the connection is established.
Note: If you cannot connect, see
Also, for problems with accessing network resources, the Windows Client and File
and Print Sharing software might not be installed and configured properly on your
computers. Please see the link to
Appendix

Starting a Computer-to-Computer (Ad Hoc) Network Connection

1. On the Settings tab page of the Smart Wizard, select or type the Network Name (SSID).
2. Select the Computer-to-Computer (Ad Hoc) network type.
3. Click Initiate Ad Hoc. The Ad Hoc Setting dialog box opens:
Figure 4-6
4. In the Start Ad Hoc field, choose the wireless standard (802.11a, 802.11b, or 802.11g) for your
Ad Hoc computer-to-computer network.
5. In the Channel field, Automatic should work. If you notice interference problems with another
nearby wireless device, select a channel that is not being used by any other wireless networks
near your wireless adapter. Use the Networks tab page to identify the channels in use in your
area.
6. Click OK.
Note: The channel number differs depending on the country. The connection speed
automatically defaults to the highest speed.
User Manual for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
B.
v4.0, February 2006
"Removing the WG311T Software" in Chapter
"Internet Networking and TCP/IP Addressing:" in
3.
4-7