Marantz SR6008 Owner's Manual page 177

Contents
2 Set the crossover frequency
40Hz / 60Hz / 80Hz (Default) / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz /
200Hz / 250Hz
%
• "Crossovers" can be set when the "Subwoofer Mode" (vpage 177)
setting is "LFE+Main", or when you have a speaker that is set to "Small".
• The default crossover frequency is "80Hz", which will work best with the
widest variety of speakers. We recommend setting to a higher frequency that
the crossover frequency when small speakers are used. For example, set to
"250Hz" when the frequency range of the speakers is 250 Hz – 20 kHz.
• For speakers set to "Small", low frequency content below the crossover
frequency is attenuated to the speakers and the low bass content is then
re-delivered to the subwoofer, or the front (L/R) speakers if they have been
set to Large.
• The speakers that can be set when "Individual" is selected differ depending
on to the "Subwoofer Mode" (vpage 177) setting.
• When "LFE" is selected, speakers set to "Small" at "Speaker Config."
(vpage 173) can be set. If the speakers are set to "Large", "Full Band" is
displayed and the setting cannot be made.
• When "LFE+Main" is selected, speakers can be set regardless of the
"Speaker Config." (vpage 173) setting.
Front panel Display
Connections Playback
Rear panel
Settings
Bass
Set subwoofer and LFE signal range playback.
2 Subwoofer Mode
Select low range signals to be reproduced by subwoofer.
LFE (Default) : The low range signal of the channel set to "Small"
speaker size is added to the LFE signal output from the
subwoofer.
LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer. This is usually the best
setting for most systems.
%
• "Subwoofer Mode" can be set when "Speaker Config." – "Subwoofer"
(vpage 173) is set to other than "No".
• Play music or a movie source and select the mode offering the strongest
bass.
• If "Front" and "Center" for "Speaker Config." (vpage 173) are set to
"Large", and "Subwoofer Mode" is set to "LFE", no sound may be output
from the subwoofers, depending on the input signal or selected sound mode.
Select "LFE+Main" if you want the bass signals to always be produced from
the subwoofer.
177
Remote
Tips Appendix
Index