Auto-Standby; Network Control; Wi-Fi Protected Setup (Wps) Settings (Pin Code Method) - Denon COCOON DSD-501 Owner's Manual

Auto-Standby

With the Auto Standby set to ON, this unit will automatically enter the
standby mode after about 30 continuous minutes of stop mode with
no operation.
• The default setting is "On".
1
Press and hold for more than
3 seconds.
Settings
2
Press + or – to select "Auto-
Standby", then press 13.
Auto-Standby(On)
Auto-Satandby Off
The unit does not go into standby automatically.
Auto-Satandby On
The unit goes into standby after 30 minutes.
NOTE
In the following situations, the Auto standby function does not operate.
• When the input source is "AUX" and a devices connected to the
AUX IN jack.
• When the input source being played is "Internet Radio"or "Music
Server".
n Exiting the menu to return to the normal mode
Press until the input source is displayed.
• The unit exits the setting mode and the normal display returns.
+ –
To return to the previous item, use or to select "Back" and then
13
press , or press .

Network Control

Set the network function on or off during standby.
• The default setting is "Off".
1
Press and hold for more than
3 seconds.
Settings
2
Press + or – to select "Network
Control", then press 13.
Network Control(Off)
Network Always On Network is on during standby. Main unit is
operable with a network compatible controller.
Network Off in
Suspends the network function during standby.
Standby
NOTE
When "Network Control" is set to "Network Always On", it consumes
more standby power.
n Exiting the menu to return to the normal mode
Press until the input source is displayed.
• The unit exits the setting mode and the normal display returns.
+ –
To return to the previous item, use or to select "Back" and then
13
press , or press .
24
Wi-Fi Protected Setup (WPS)
Settings (PIN code method)
Sets the wireless connection using WPS (PIN code method).
This setting item is not displayed when using a wired connection.
Before turning this unit on, make sure that an LAN cable is not
connected to this unit.
When a LAN cable is connected, set the power to standby and
disconnect the LAN cable.
1
Press and hold for more than
3 seconds.
Settings
2
Press + or – to select "WPS(PIN)",
then press 13.
WPS(PIN)
• "Searching" is displayed, and the access point you have set is
displayed.
3
Press + or – to select the access point whose PIN code
you want to display, and press 13.
The PIN code number is displayed.
4
Set this PIN code to the register.
• For how to register the PIN code, see the owner's manual of your
router with access point.
• When connection is established with access point, "Connected!"
is displayed.
n Exiting the menu to return to the normal mode
Press until the input source is displayed.
• The unit exits the setting mode and the normal display returns.
+ –
To return to the previous item, use or to select "Back" and then
13
press , or press .