Install The Mirrors - Honda ST1300 2006 Setup Instructions

7. Install the front wheel (cont.).
Make sure the axle end is flush with the front
fork leg outer surface as shown.
Tighten the left axle pinch bolts to the
specified torque.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft)
On the ST1300A, verify the clearance between
the ABS front pulser ring and sensor.
Clearance specification:
0.4 - 1.2 mm (0.02 - 0.05 in)
If outside the clearance specification range,
recheck the wheel installation.

8. Install the mirrors.

PARTS
Right mirror cover
Left mirror cover
Right mirror cover rubber
Left mirror cover rubber
Right rear view mirror
Left rear view mirror
Flange bolt 6 x 20 mm
Hose clip
Remove and discard the shipping bolts.
Install the right and left rear view mirrors
using two 6 x 20 mm flange bolts on
each side.
Torque the bolts.
Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the two hose clips as shown.
©2006 American Honda Motor Co., Inc. - All Rights Reserved
QTY
1
1
1
1
1
1
4
4
PINCH BOLTS
SENSOR
PULSER RING
HOSE CLIPS
SHIPPING BOLTS
(discard)
AXLE
PULSER RING
SENSOR
0.4 - 1.2 mm (0.02 - 0.05 in)
6 x 20 mm FLANGE BOLTS
9