Install The Mirrors - Honda ST1300 2003 Setup Instructions

2003 ST1300 / ST1300A

9. Install the mirrors.

Remove the shipping bolts and discard. Install the right
and left rear view mirrors using two 6 x 20 mm flange
bolts on each side.
Tighten the bolts to the specified torque.
Torque: 9 ft-lbs (1.2 kg-m, 12 N
Install the two hose clips.
Connect the harness terminals as shown, then push
the end of the suspension band into the hole in
the body.
Install the mirror rubber cover, then install the
mirror cover.
Check that the mirror rubber cover and mirror cover are
installed securely.
8
.
m)
HOSE CLIP
HOLE
SUSPENSION
BAND
MIRROR COVER
©2003 American Honda Motor Co., Inc. - All Rights Reserved
6 X 20 MM FLANGE BOLTS
SHIPPING BOLTS
(DISCARD)
MIRROR
RUBBER
COVER
TERMINALS