Fortinet FortiGate 60 Installation Manual page 35

NAT/Route mode installation
FortiGate-60 Installation Guide
• One DMZ port for connecting to a DMZ network.
• Modem is the interface for connecting an external modem to the FortiGate-60. See
"Configuring the Modem interface" on page 36
Note: You can also connect the WAN1 and WAN2 interfaces to different Internet connections to
provide a redundant connection to the Internet.
To connect the FortiGate unit:
1 Connect the Internal interface connectors to PCs and other network devices in your
internal network.
The Internal interface functions as a switch, allowing up to four devices to be
connected to the internal network and the internal interface.
2 Connect the WAN1 interface to the Internet.
Connect to the public switch or router provided by your Internet Service Provider. If
you are a DSL or cable subscriber, connect the WAN1 interface to the internal or LAN
connection of your DSL or cable modem.
3 Optionally connect the WAN2 interface to the Internet.
Connect to the public switch or router, usually provided by a different Internet Service
Provider. If you are a DSL or cable subscriber, connect the WAN2 interface to the
internal or LAN connection of your DSL or cable modem.
4 Optionally, connect the DMZ interface to your DMZ network.
You can use a DMZ network to provide access from the Internet to a web server or
other server without installing the servers on your internal network.
Figure 10: FortiGate-60 NAT/Route mode connections
Wireless Network
FortiGate-60
Internal Network
Internal
INTERNAL
PWR STATUS 1 2 3 4 DMZ
LINK 100 LINK 100 LINK 100 LINK 100 LINK 100
WAN1
Broadband (cable or DSL)
T1
Internet
01-28008-0018-20050128
Connecting the FortiGate unit to the network(s)
DMZ
WAN1 WAN2
LINK 100 LINK 100
WAN2
DMZ Network
Web Server
Mail Server
35