Starting The Setup Wizard; Connecting The Fortigate Unit To The Network(S) - Fortinet FortiGate 60 Installation Manual

Connecting the FortiGate unit to the network(s)

Starting the setup wizard

Connecting the FortiGate unit to the network(s)
34
Table 8: Setup wizard settings
Antivirus
1 In the web-based manager, select Easy Setup Wizard.
Figure 9: Select the Easy Setup Wizard
2 Follow the instructions on the wizard pages and use the information that you gathered
in Table 6 on page 28
3 Select the Next button to step through the wizard pages.
4 Confirm the configuration settings, and then select Finish and Close.
Note: If you change the IP address of the interface you are connecting to, you must connect
through a web browser again using the new address. Browse to https:// followed by the new IP
address of the interface. If the new IP address of the interface is on a different subnet, you may
have to change the IP address of your computer to the same subnet.
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For each server located on your
internal network the FortiGate unit adds a WAN1->Internal firewall policy.
You are now finished the initial configuration of the FortiGate unit.
When you have completed the initial configuration, you can connect the FortiGate unit
between your internal network and the Internet.
The following network connections are available on the FortiGate-60 unit:
• A 4-port switch for connecting the FortiGate internal interface to your internal
network,
• One WAN1 port for connecting to your public switch or router and the Internet,
• One WAN2 port for connecting to a second public switch or router and the Internet
for a redundant Internet connection,
High Create a protection profile that enables virus
scanning, file blocking, and blocking of oversize
email for HTTP, FTP, IMAP, POP3, and SMTP. Add
this protection profile to a default firewall policy.
Medium Create a protection profile that enables virus
scanning, for HTTP, FTP, IMAP, POP3, and SMTP
(recommended). Add this protection profile to a
default firewall policy.
None Do not configure antivirus protection.
Select one of these security levels to protect your network from viruses.
and Table 8 on page 33
01-28008-0018-20050128
NAT/Route mode installation
to fill in the wizard fields.
Fortinet Inc.