Connecting Lp Cylinder And Hose / Regulator To Grill - Charmglow 8532 Owner's Manual

Note: If burner does not light or flame is too low, you may have spider or other insect blockage in
burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under
Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder
and Hose/Regulator to Grill.
LIGHTING THE ROTISSERIE BURNER:
1. Open lid before lighting burner.
2. Make sure control knob is in the "OFF" position.
3. Push and turn the control knob to the "HIGH" position.
4. Press the electronic igniter and hold for 3 – 5 seconds to light
burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to
"OFF", wait 5 minutes to allow gas to dissipate and repeat lighting
procedure.
6. To turn off, turn the control knob clockwise until it locks in the
"OFF" position. This does not turn off the gas flow from the
cylinder.
MATCH LIGHTING THE ROTISSERIE BURNER:
1. Open grill hood before lighting rotisserie burner.
2. Make sure control knob is in the "OFF" position.
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the lower edge of burner.
4. Push and turn the control knob to the "HIGH" position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected. See "Trouble Shooting" section of this manual.
Note: If burner does not light or flame is too low, you may have spider or other insect blockage in
burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under
Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder
and Hose/Regulator to Grill.
LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is in the "OFF" position.
3. Push and turn side burner control knob to the "HIGH" position.
4. Press the electronic igniter on the main control panel and hold for
3 – 5 seconds to light burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF",
wait 5 minutes to allow gas to dissipate and repeat lighting
procedure.
6. To turn off, turn the control knob clockwise until it locks in the "OFF"
position.
11