Table of Contents
Advertisement
Tool operators and maintenance personnel must always
comply with the safety precautions given in this manual,
and on the stickers and tags attached to or on the tool
and hose(s).
These safety precautions are for your safety. Review
them carefully before operating the tool or performing
any maintenance or repairs.
Supervising personnel may specify additional precau-
tions for your work area to comply with company policies
and local safety regulations. Enter any added precau-
tions in the space provided in this manual.
The CD10 Hydraulic Core Drill will provide safe and
dependable service if operated in accordance with the
instructions given in this manual. Read and understand
this manual and any stickers and tags attached to the
tool and hoses before operation. Failure to do so could
result in personal injury or equipment damage.
•
Operator must start in a work area without bystand-
ers. The operator must be familiar with all prohibited
work areas such as excessive slopes and danger-
ous terrain conditions.
•
Establish a training program for all operators to en-
sure safe operations.
•
Do not operate the tool unless thoroughly trained or
under the supervision of an instructor.
•
Always wear safety equipment such as goggles,
head protection, and safety shoes at all times when
operating the tool.
•
Do not inspect or clean the tool while the hydraulic
power source is connected. Accidental engagement
of the tool can cause serious injury.
•
Do not operate this tool without first reading the Op-
erating Instructions.
•
Never operate the tool if you cannot be sure that
underground utilities are not present. Underground
electrical utilities present an electrocution hazard.
Underground gas utilities present an explosion haz-
ard. Other underground utilities may present other
hazards.
•
Do not wear loose fitting clothing when operating the
tool. Loose fitting clothing can get entangled with the
tool and cause serious injury.
SAFETY PRECAUTIONS
•
Supply hoses must have a minimum working pres-
sure rating of 2500 psi/175 bar.
•
Be sure all hose connections are tight.
•
The hydraulic circuit control valve must be in the
OFF position when coupling or uncoupling the tool.
Wipe all couplers clean before connecting. Failure
to do so may result in damage to the quick couplers
and cause overheating. Use only lint-free cloths.
•
Do not operate the tool at oil temperatures above
140 °F/60 °C. Operation at higher oil temperatures
can cause operator discomfort and may cause dam-
age to the tool.
•
Do not operate a damaged, improperly adjusted, or
incompletely assembled tool.
•
To avoid personal injury or equipment damage, all
tool repair, maintenance and service must only be
performed by authorized and properly trained per-
sonnel.
•
Do not exceed the rated limits of the tool or use the
tool for applications beyond its design capacity.
•
Always keep critical tool markings, such as labels
and warning stickers legible.
•
Always replace parts with replacement parts recom-
mended by Stanley Hydraulic Tools.
•
Check fastener tightness often and before each use
daily.
•
Warning: Use of this tool on certain materials during
demolition could generate dust potentially contain-
ing a variety of hazardous substances such as as-
bestos, silica or lead. Inhalation of dust containing
these or other hazardous substances could result
in serious injury, cancer or death. Protect yourself
and those around you. Research and understand
the materials you are cutting. Follow correct safety
procedures and comply with all applicable national,
state or provisional health and safety regulations
relating to them, including, if appropriate arranging
for the safe disposal of the materials by a qualified
person.
CD10 User Manual ◄ 5
Advertisement
Table of Contents
