Technical Data; Pc Requirements; Action - Philips SA4ACT02 User Manual

9 Technical data

Power
Power supply: 90 mAh Li-ion polymer
internal rechargeable battery
Play time¹
Audio (.mp3): up to 12 hours
Software
and transfer music
Connectivity
Headphone 3.5 mm
USB 2.0 High speed
Sound
Channel separation: 45 dB
Frequency Response: 20-18,000 Hz
Output power: 2 x 2.4 mW
Signal to noise ratio: > 84 dB
Audio playback
Supported formats:
MP3
Bitrate: 8-320 kbps and VBR
Sampling rates: 8, 11.025, 16, 22.050,
32, 44.1, 48 kHz
WMA (unprotected)
Bitrate: 5-320 kbps
Sampling rates: 8, 11.025, 16, 22.050,
32, 44.1, 48 kHz
WAV
Storage media
Built-in memory capacity²:
SA4ACT02 2 GB NAND Flash
SA4ACT04 4 GB NAND Flash
Media transfer³
Windows Explorer (drag and drop)
Songbird (sync)
16 EN
Note
¹ Rechargeable batteries have a limited number of
charge cycles. Battery life and number of charge cycles
vary by use and settings.
² 1 GB = 1 billion bytes; available storage capacity is
less. Full memory capacity may not be available as some
memory is reserved for the player. Storage capacity
is based on 4 minutes per song and 128-kbps MP3
encoding.
³ Transfer speed depends on operating system and

PC requirements

Windows® XP (SP3 or above) / Vista / 7
Pentium III 800 MHz processor or higher
512 MB RAM
500 MB hard disk space
Internet connection
Windows® Internet Explorer 6.0 or later
CD-ROM drive
USB port
Water-resistance
meet the Ingress Protection Rating (IP Code)
IPX5 of IEC60529:
The test for compliance with IPX5
is conducted for each surface of the
enclosure of the player, except for the
headphones section and when the USB
cover of the player is closed properly;
The player can work normally when it is
subject to water that jets from a nozzle
with an opening of 6.3-mm diameter, at a
duration of more than three minutes, and
from a distance of about 3 meters.