Returning The Stored Vehicle To Service - Husqvarna HUV 4213-GXP Owner's Manual

Hide thumbs Also See for HUV 4213-GXP:

Owner's manual (52 pages)

Table Of Contents

Table of Contents

CLOSED (OFF) POSITION

(SELECTOR IS ALIGNED

WITH OFF MARKINGS ON THE SIDES OF VALVE)

OFF

VIEWED FROM SELECTOR

SIDE OF VALVE

Figure 12 Fuel Shut-off Valve – Closed Position

7. Disconnect the battery cables, negative (–) cable first. See WARNING "To avoid unintentionally start-

ing..." on page 10.

8. Batteries should be clean and free of corrosion. Wash tops and terminals of batteries with a solution of

baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse solution off bat-

teries. Do not allow this solution to enter the batteries. Be sure terminals are tight. Let the terminals dry

and then coat them with Battery Terminal Protector Spray (P/N 603 00 00-03).

9. To protect the engine, remove spark plug and pour 1/2 ounce (14.2 mL) of SAE 10 weight oil into the

engine through the spark plug hole. Rotate engine crankshaft by hand several times and then install the

spark plug.

10. Lower the passenger side seat.

11. Lower the cargo bed. See WARNING "For vehicles with cargo beds..." on page 10.

12. Adjust tires to recommended tire pressure. See Vehicle Specifications on page 38.

13. Perform semiannual periodic lubrication. See Periodic Lubrication Schedule on page 28.

14. Thoroughly clean front body, rear body, seats, cargo bed, engine compartment, and underside of vehicle.

15. Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling.