JVC KD-LX50R Instructions Manual page 55

To make the front panel look flat (hiding the control panel)
FLAT PANEL
When operating the receiver using the remote control, you can hide the control panel to make
the front panel look flat. When shipped from the factory, "FLAT OFF" is selected.
• FLAT ON: The control panel will not come out when you turn on the unit.
To use the control panel, press 4
no operation is done for about 10 seconds, it automatically goes back into the
receiver.
• FLAT OFF: You can use the control panel normally.
Note:
When "FLAT ON" is selected, you can eject a CD by holding 4
To change the FM tuner selectivity
In some areas, adjacent stations may interfere with each other. If this interference occurs,
noise may be heard. This unit has been preset to automatically reduce this interference noise
("AUTO") when shipped from the factory.
• AUTO: When this type of interference occurs, this unit automatically increases the
tuner selectivity so that interference noise will be reduced. (But the stereo
effect will also be lost).
• WIDE: Subject to the interference from adjacent stations, but sound quality will not
be degraded and the stereo effect will not be lost.
so that the control panel comes out. If
.
— IF FILTER
—
55