Honeywell KMD 250 Pilot's Manual page 62

3. Press the NEW WPT
Softkey to display the USER
WAYPOINT EDIT display as
shown in Figure 1-69.
The system default waypoint
identifier will be a naming con-
vention as shown in the IDENT
field. The default identifier will
increment starting
USR000. The user can also
enter any identifier desired, but
limited to any combination of
six alphanumeric characters. If
the default identifier is accept-
able, proceed to step 5.
4. To enter a waypoint identi-
fier other than the system
default, turn the Rotary Knob
one increment and the first
character will be highlighted as
in Figure 1-70. If the desired
identifier is less than six char-
acters, press the CLEAR
IDENT Softkey to clear the
IDENT field. Otherwise, turn
the Rotary Knob to enter the
desired first character. Use the
Joystick to go to the next field
and again use the Rotary Knob
to enter the next desired char-
acter and so on until complete.
5. The current date and time
default to the two fields under
the waypoint
Remarks regarding the way-
point can be entered in these
fields in place of the date and
time.
If remarks are desired, use the Joystick to place the cursor on the first
line containing the date as shown in Figure 1-71.
Rev 2 Apr/2004
with
identifier.
1-43
User Waypoints
Figure 1-69
Figure 1-70
Figure 1-71
KMD 250 Pilot's Guide