Table of Contents
Advertisement
System Messages
Message Text
Nav Data Referenced To
True North
Nav Data Referenced To
User-Defined Mag Var
No Valid FIS Subscriptions
Regulated 12V Out Of
Range. Switch Unit Off
Regulated 5V Out Of Range.
Switch Unit Off
Regulated 3.3V Out Of
Range. Switch Unit Off
Regulated 3V Out Of Range.
Switch Unit Off
Stormscope Failure
Traffic System Failure
Unit Configuration Cleared
To Defaults
Unit History Data Cleared To
Defaults
Rev 4 Aug/2007
Description
This message is displayed when a user-defined magnetic variation of 0
degrees is being used for navigation data. Check Navigation Setup
Page.
This message is displayed when a user-defined magnetic variation is
being used for navigation data. Check Navigation Setup Page.
This message occurs when no current FIS subscriptions are available.
FIS data will be unavailable. Check the subscription status on the Aux
Menu FIS Subscription page. Go to www.bendixking.com to purchase a
new VDL subscription. Go to www.xmradio.com/weather to purchase a
new XM subscription. This is the only indication received when an XM
subscription has expired.
The internal 12V power supply is operating outside its acceptable range.
Turn the unit off and back on. If the message persists then the unit may
need service.
The internal 5V power supply is operating outside its acceptable range.
Turn the unit off and back on. If the message persists then the unit may
need service.
The internal 3.3V power supply is operating outside its acceptable range.
Turn the unit off and back on. If the message persists then the unit may
need service.
The internal 3V power supply is operating outside its acceptable range.
Turn the unit off and back on. If the message persists then the unit may
need service.
The KMD 250 is unable to communicate with the Stormscope® or it has
reported a failure. See the Stormscope® page for error codes and the
Stormscope® users manual for more information.
The KMD 250 is unable to communicate with the traffic system or the
traffic system has reported a failure.
A problem was detected in the memory used for storing the unit configu-
ration settings. The settings have been set back to factory defaults. In
most cases the unit will need to be reconfigured by an authorized
Bendix/King installer in order to operate properly.
A problem was detected in the memory used to store unit history informa-
tion. The memory has effect on operation, it simply means less informa-
tion will be available to the service center if the unit requires service.
5-4
KMD 250 Pilot's Guide
Advertisement
Table of Contents
