Using The Quick Arm; Changing Modes While Your System Is Armed; Disarming Your System - GE NetworX NX-1192E User Manual

¾
The LCD display will read
"Instant"
entry/exit doors do NOT have
an entry delay.
D.

USING THE QUICK ARM

The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user to arm
the security system in the AWAY mode by pressing EXIT. The system can be quick
armed in the STAY mode by pressing [STAY]. This feature is used for ARMING ONLY,
and will not disarm the security system. This is ideal for a maid or baby sitter code, etc.
E.

CHANGING MODES WHILE YOUR SYSTEM IS ARMED

1. Pressing STAY will turn on/off (toggle) a delay on Entry/Exit doors. The
"Instant" message will toggle on the LCD display.
2. (Optional, if programmed.) Press BYPASS at this time to turn on/off (toggle)
all designated interior zones. If all interior zones are not bypassed, the stay
light will extinguish.
3. (Optional, if programmed.) When armed, pressing EXIT will start the exit
delay, enabling you to leave the building.
(
IMPORTANT! An alarm will be created if the "Instant" message is ON at this
time and you re-enter the building. You may re-initiate an entry/exit delay by pressing
STAY again. The "Instant" message will disappear.
F.

DISARMING YOUR SYSTEM

When you enter the protected area through one of the designated Entry/Exit doors, the
keypad control will sound a continuous tone for the duration of the entry delay time, or
until you enter a valid code.
10
meaning the
6\VWHP$UPHG
,QVWDQW