Installation Instructions - Hotpoint 23 Series Owner's Manual And Installation

Installation
Instructions
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
• Skill level – Installation of this appliance
requires basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes
• Proper installation is the responsibility of
the installer.
• Product failure due to improper installation
is not covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS)
If the refrigerator has an icemaker, it will
have to be connected to a cold water line.
An approved water supply kit is available at
extra cost from your local distributor.
Maximum permissible inlet water pressure—
8.2 bars.
Minimum permissible inlet water pressure—
2.8 bars.
Installation of the icemaker must be done by
a qualified service technician.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the
temperature will go below 16°C because it
will not run often enough to maintain proper
temperatures.
• Do not install the refrigerator where the
temperature will go above 37°C because it
will not perform properly.
• Install it on a floor strong enough to support
it fully loaded.
Save these
Observe all
Refrigerator
CLEARANCES
Allow the following clearances for ease
of installation, proper air circulation and
plumbing and electrical connections:
23'
• Sides 4 mm
• Top 25 mm
• Back 13 mm
DIMENSIONS
*Height does not include hinge.
23
**Depth includes handle.
A* 1733 mm
B 908 mm
C** 738 mm
D 1156 mm
E 1232 mm
F 989 mm
G 1361 mm
H 1023 mm
A
B
C
24
Model 23
E
H
D
G
F