Control Panel - Vita-Mix Touch and GO Owner's Manual

ontrol Panel
C
Start/Stop
Six Factory Pre-Set
Programs
Touch and Go
ON/OFF switch - Located on the side of the Motor Base the ON/OFF
switch controls the power to the machine. With the machine plugged in,
switch the machine to ON to ready the machine for blending.
START/STOP button - Pressing START/STOP once starts and runs the
machine and turns the blades. Press the START/STOP button again to
stop the machine and the blades. (NOTE: Pressing one of the PRE-SET
PROGRAM buttons, while the motor is running, will also stop the machine.)
SPEED CONTROL button - Press the
speed of the blades in increments of 1%, up to 100%. Press the
to gradually decrease the speed of the blades in increments of 1%, down
to 7%. SPEED CONTROL is used to set the blending speed of the PULSE
buttons (See Instructions, pg.15) and the START/STOP button (See
Instructions, pg. 16). NOTE: These settings will reset if the power is shut off.
PRE-SET PROGRAM buttons - These buttons, numbered 1 thru 6, are
pre-programmed blending cycles designed for the most commonly made
drinks. Depending on the viscosity of the drink you are creating, pressing
one of the six PRE-SET PROGRAM buttons will run the machine for a
full cycle. The machine will stop by itself when the cycle is complete.
A cycle varies in speed and length, see the Instructions on page 14 for
a complete description of the range of each PRE-SET button.
4
Speed Control
Owner Controls
TM Blending Station
Display Window
High/Low Pulse
®
button to gradually increase the
button