Table of Contents
Advertisement
MAKING EMBROIDERY ADJUSTMENTS
Using the Thread Trimming
Function (JUMP STITCH TRIM)
The thread trimming function
automatically trim any excess thread jumps within
the color. This function is initially turned on. To
turn this function off, press
. This function can be turned on or off during
embroidering.
*
Your customized setting remains after turning the
machine off and on.
a Jump stitch
Note
• When this function is turned on, use the
included ball point needle 75/11 for embroi-
dering patterns with short jump stitches such
as alphabet characters. Using other needles
may cause the thread to break.
a
Press
.
236
b
will
key and then
■ Selecting the Length of Jump Stitch
Press
to turn off the thread trimming
function.
→ The key will display as
*
The machine will not trim the thread before moving
to the next stitching.
Not to Trim
When the thread trimming function
on, you can select the length of the jump stitch not
to trim the thread. This function can be turned on or
off during embroidering.
Select a setting from 5 mm to 50 mm in 5 mm
increments.
*
Your customized setting remains after turning the
machine off and on.
Press
or
to select the length of jump stitch.
For example: Press
to select 25 mm (1 inch)
and the machine will not trim a jump stitch of 25
mm or less before moving to the next stitching.
Note
• If design has many trims it is recommended
to select a higher jump stitch trim setting in
order to reduce the amount of excess tails
on backside of fabric.
• The higher number of the jump stitch length
selected, the fewer number of times the
machine will trim. In this case, more jump
stitches remain on the surface of the fabric.
is turned
Advertisement
Chapters
Table of Contents
Troubleshooting
