Installation Space - Toshiba MMK-AP0071H Installation Manual

Installation space

Reserve space required to install the indoor unit and
for service work.
Keep 300mm or more for clearance between top plate
of the indoor unit and the ceiling surface.
The transport brackets are provided. Following to the table, remove the brackets according to direction of pipe.
(Left, right, center) (For AP0071H to AP0181H, (left) and (right) transport brackets only are provided.)
Pipe side piping
Right side piping
Remove transport bracket (right) only.
Rear side piping
Left side piping Remove all transport brackets.
REQUIREMENT
After removing of the transport brackets, do not
apply force on the lower cabinet. It is to prevent
deformation and breakage.
Pipe connecting position
<Front view>
Top end of installation plate
Drain pipe
<Bottom view>
Shipping from factory (Left side piping)
Parts to be removed
(Including installation plate)
Liquid side
Gas
side
60
110
Gas pipe 440
Liquid pipe 540
Drain pipe 560
300 or more
• Remove the installation plate.
Transport bracket
(Right)
210
Installation plate (Accessory)
77
Refrigerant pipe connecting port
gas side A
380
Left and
right side piping
(Knockout hole)
Model MMK-
AP0071H to AP0121H
AP0151H, AP0181H
AP0241H
4
Installation plate
Transport bracket
(Center)
Refrigerant pipe connecting port
liquid side B
450
Drain pipe
connecting port
480
A
Ø9.5
Ø12.7
Ø15.9
300 or more
Transport bracket
(Left)
B
Ø6.4
Ø6.4
Ø9.5