How To Use Accessories - Eureka AS1100 series Owner's Manual

Before using accessories
• Pull out cord to desired length. Do not pull
past red line (Fig.1). Push cord into cord clip.
• Move brush roll lever to off position and put
vacuum in an upright position (Fig. 2).
• Turn air path selector knob to 'tools' (Fig. 3).
• When finished vacuuming, press switch to
retract cord (Fig. 4).
2-Position wand
WAND
1 1
(wand 2 on some models or available for purchase)
Loosen wand and hose from vacuum.
• Push tool onto end of wand (Fig. 5).
• Short wand: Push hose release button to
remove wand 1. Attach tool to end of hose.
WAND
2 2
• Longer wand: Slide off wand 2 and turn over,
then push opposite end onto wand 1.
Dusting brush
Use for furniture, drapes and vents.
Crevice tool
Use for baseboards, corners
and tight spaces.
Turbo nozzle
(on some models or available for purchase)
Use for furniture and stairs.
Stair hose
(on some models or available for purchase)
Make sure vacuum is below you,
pushed against the bottom step.
• Attach stair hose to end of hose
or wand.
• Attach turbo nozzle to end of
stair hose.
NOTE: Hose length can be increased by
releasing the hose from the hose retainer
on back of unit. Reposition hose inside
hose retainer after using accessories.
Eureka Customer Service HELPLINE 1-800-282-2886

How to use accessories

When using tools, always place handle in upright
position and move brush roll lever to off position.
Fig.1
Fig.3
Fig.5
C A U T I O N
Fig.2
Fig.4
Wand 1
Wand 2
(on some models)
www.eureka.com 3 3