How To Identify Parts Of Vacuum Cleaner; Maintenance Schedule - Eureka AS1100 series Owner's Manual

How to identify parts of vacuum cleaner

Hose
Air path
selector knob
Power cord
Cord reel
Suction plates
Maintenance Schedule is also located on back side of dust cup.
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. Moving parts! Power switch is marked
Washable filter
DCF25
Filter assembly
Brush roll
2 Eureka Customer Service HELPLINE 1-800-282-2886
SPECIAL FEATURES
Available on some models
Handle
Turbo nozzle
(on some models)
Dust cup release
Filter assembly
WAND
(located inside dust cup)
2 2
Dust cup
Wand 2
Exhaust/HEPA
filter compartment
(located behind dust cup)
Height adjustment knob
Brush roll cover

Maintenance schedule

N O T I C E
To view our
instructional video,
please visit
www.eureka.com
Exhaust/HEPA
filter EF6
Type S belt
Turbo cover
Turbo
nozzle
Stair hose
Crevice tool
Dusting brush
Cord rewind switch
Power switch
Brush roll lever
Handle release
Exhaust / HEPA filter EF6
Replace within 6 months
Lift latch and
remove dust cup.
Lift out filter and replace. Reinstall
cover and snap into place.
HEPA filter cover must be in place at all times.
Remove vacuum cover for
belt change instructions
Remove 4 screws and lift off cover.
Empty cup after each use
Press lever to
release bottom lid.
Debris will empty.
TYPE S BELT – Replace worn, cut or out of shape belt
Cord clip
Carry handle
Wand
Lower hose retainer
Base hose
I
Washable dust cup filter DCF25
Clean as needed to maintain suction
Pull filter latch to release dust cup
Press down tab
cover. Lift out cup filter. Wash filter;
and remove
allow to air dry thoroughly.
filter cover.
Lift out filter tube and screen.
Shake off dust. Rinse; dry
thoroughly.
Align tabs on filter tube, screen
and cup; drop into position.
Reinstall cup filter. Close cover.
Filters and screen must be in place for cover to lock.
!
Periodically check hose
for clogs in order to
Close lid until
it clicks.
prevent air restriction.
BRUSH ROLL – Clean monthly
www.eureka.com
for On/Off.