System Board - HP Spectre Maintenance And Service Manual

System board

NOTE: The system board spare part kit includes replacement thermal material.
Description
For use only with computer models equipped with an Intel 1.7GHz processor, but not WWAN
capability (includes replacement thermal material)
For use only with computer models equipped with an Intel 1.9GHz processor, but not WWAN
capability (includes replacement thermal material)
For use only with computer models equipped with an Intel 2.0GHz processor, but not WWAN
capability (includes replacement thermal material)
Before removing the system board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the base enclosure (see
5. Remove the battery (see
6. Remove the WLAN module (see
7. Remove the fan (see
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
●
RTC battery (see
●
Power connector cable (see
●
Fan (see
●
Heat sink (see
●
WLAN module see
●
Hard drive (see
●
USB/Audio (see
●
Display panel cable (see
●
RJ-45 cover (see
Remove the system board:
1. Remove the following cables:
●
USB/Audio board cable (1)
●
Power button board cable (2)
●
Display panel cable (3)
Battery on page
Fan on page
RTC battery on page
Power connector cable on page
Fan on page 35).
Heat sink on page
(WLAN module on page
Solid-state drive on page
USB/Audio board on page
Display panel on page
RJ-45 module cover on page
Base enclosure on page
29).
WLAN module on page
35).
31)
40)
34).
33).
43),
51).
35).
Spare part number
689957-001
689958-001
689959-001
27).
34).
47)
Component replacement procedures 37