D-Link DIR-615 User Manual page 39

Secton  - Configuraton
This will allow you to open a single port. If you would like to open a range of ports, refer to the next page.
Name:
Enter a name for the rule or select an application
from the drop-down menu. Select an application
and click << to populate the fields.
IP Address:
Enter the IP address of the computer on your
local network that you want to allow the incoming
service to. If your computer is receiving an IP
address automatically from the router (DHCP),
you computer will be listed in the "Computer
Name" drop-down menu. Select your computer
and click <<.
Private Port/
Enter the port that you want to open next to Private
Public Port:
Port and Public Port. The private and public ports
are usually the same. The public port is the port
seen from the Internet side, and the private port
is the port being used by the application on the
computer within your local network.
Protocol Type:
Select TCP, UDP, or Both.from the drop-down
menu.
Inbound Filter:
Select Allow. All (most common) or a created
Inbound filter. You may create your own inbound filters in the Advanced.>.Inbound.Filter page.
Schedule:
The schedule of time when the Virtual Server Rule will be enabled. The schedule may be set to Always, which will allow the
particular service to always be enabled. You can create your own times in the Tools > Schedules section.
D-Lnk DIR-615 User Manual 5