Installation
Wall Termination
Joint covers
fig. 10
Tee with cover plate
Tee with cover plate
Straight sections
Basement Installation
To install a DVC 500 in a basement you will
need additional DVC vent sections. These sections
are made with a 316-grade stainless steel liner and
a 20 gauge galvaneeled outer shell. Each joint is
sealed with a gasket and is bolted together with 4
bolts. In order to maintain the best seal, there are no
adjustable sections. There are straight, 45 degree,
and Tee fittings. Refer to Page 14 for all of the sec-
tions available.
Never use venting other than Harman DVC
venting inside the building. It is the only vent
certified for this appliance.
Refer to page 12 & 14 to calculate which sec-
tions will be needed for your installation.
Corner Installation
A corner installation requires a 45 degree section
in addition to the standard wall termination.
In order to cut a hole in the wall that will allow
the stove to be placed an equal distance to each wall,
refer to Page 13.
D
11
fig. 11