Zone Control - Kenwood DNN9250DAB Instruction Manual

Loudness
Set the amounts of boost of low and high
tones.
DNN9250DAB/ DNR8025BT: "OFF", "Low", "High"
DNN6250DAB: "OFF", "ON"
SW Level
Adjust the subwoofer volume. This setting is
not available when subwoofer is set to "None".
Speaker setup (P.135).
See

Zone Control

You can select different sources for both
front and rear positions in the vehicle.
1
Touch [ ] on any screen.
2
Touch [Audio].
Audio screen appears.
3
Touch [Zone Control].
Zone Control screen appears.
4
Touch [Dual Zone].
5
Set each source as follows.
[D] (Front Source, Rear Source)
Select the audio source for each.
[S], [R] (Rear VOL.)
Adjust the rear channel volume.
[Single Zone]
Touch to turn off the dual zone function.
NOTE
• When the rear speaker sound is switched, the
audio source that is output at the AV OUTPUT
terminal is also switched to the same source.
• When the dual zone function is set to on, the
following functions are not available.
– Output from the subwoofer
– Subwoofer Level/Bass Boost
– Equalizer Control/Sound Effect/Listening
(P.138, 140, 142)
Position
– DSP Bypass Control/Speaker Setup/Car Type
(P.137, 135, 136)
Setup
Return to the Top page
Controlling Audio
(P.137)
139